Power Factor Calculator

This calculator solves for power factor instead of asking you to supply one. Enter real and apparent power, or the voltage, current and wattage a meter gives you, and it returns the power factor, the phase angle, the reactive power and how much extra current a poor figure costs the supply. A third action sizes a correction bank, giving the kvar rating and the capacitance per phase for a single phase, delta or wye connection. Two magnitudes cannot say whether the current leads or lags, so no direction is claimed, and the correction arithmetic assumes a lagging load.

Calculator Type
Those Two Figures Are In

The two figures a utility bill or a power meter gives you. The power factor is their ratio, so any consistent pair of units works.

What the meter records and what the energy part of the bill is based on.
Volts times amps. It is what a transformer, generator or UPS is rated in.
Widget

What a clamp meter and a power meter give you on site. The apparent power comes from the voltage and current, and the power factor is the real power divided by it.

For three phase, enter the line to line voltage and the line current.
The reading from a wattmeter or the kW figure on a meter, multiplied out into watts.
Widget

How much capacitive reactive power it takes to lift a lagging load from the power factor it has to the one you want, and what capacitance that is at your supply voltage.

Correction does not change the real power, so this is the same before and after.
Correcting all the way to 1 is rarely done, because a small change in load then tips the bank into over-correction.
Line to line for a three phase supply.
50 Hz across most of the world, 60 Hz in North America.
A delta bank needs a third of the capacitance of a wye bank for the same kvar, because each capacitor sits across the full line voltage.
Widget