PSI Calculator

PSI is pounds of force spread over a square inch, and this tool gets there several ways. Enter a force and an area, or a circle or rectangle it presses on, and it returns the pressure; enter a reading in bar, kPa, atmospheres, mmHg, inches of mercury or feet of water and it converts it; enter the height of a column of liquid and it returns the static pressure at the bottom; enter a cylinder bore and a psi and it returns the push and pull force. A fifth form works the other way, turning a gauge pressure into feet or metres of head for a liquid of any specific gravity. Every figure comes out in eleven units at once, and the gauge tab also shows the absolute pressure. The conversion factors are all definitions rather than measurements, so nothing here is an estimate.

Calculator Type
Force Unit
Area Unit
Unit for Those Lengths
Only the boxes for the option you pick are read; leave the others blank.
Widget
Unit It Is In
A negative value is fine for a gauge reading below atmospheric.
Widget
Height Unit
Straight up from where you are measuring to the surface. How far the pipe runs sideways makes no difference when nothing is flowing.
Water is 1. Diesel is about 0.85, seawater 1.025, mercury 13.534.
Widget
Pressure Unit
A North American hydraulic system is rated in psi and an ISO one in bar or MPa. 1,000 psi is 68.9476 bar.
Unit for the Bore and Rod
Both diameters are read in this unit and the piston area comes back in the square of it.
Answer the Force In
The inside diameter of the barrel, not the outside of the tube.
Leave blank for the push stroke only. Fill it in and the pull stroke is worked out as well.
Widget
Pressure Unit
A gauge reading, so the head is measured from the open surface of the liquid.
Water is 1. Diesel is about 0.85, seawater 1.025, mercury 13.534.
Widget