RC Filter Calculator

This works out the corner frequency of a single-pole RC filter from fc = 1 / (2 pi R C), in either the low-pass or the high-pass arrangement. Enter a resistor and a capacitor in any usual unit and it returns the cutoff, the time constant, the step rise time and the gain an octave and a decade into the stop band. Two other modes run it backwards: solve for the resistor or capacitor that puts the corner where you want it, with the nearest stocked E24 or E6 part beside it, or give a signal frequency and get the gain, the loss in decibels and the phase shift. It assumes an ideal source and no load, so a real driving impedance will move the corner.

Calculator Type
Resistance Unit
Capacitance Unit
The resistor and the capacitor are in series either way. Which node you take the output from decides which half of the spectrum gets through.
Widget
Frequency Unit
Capacitor Unit
Resistor Unit
Used when you are solving for the resistor.
Used when you are solving for the capacitor.
Widget
Resistance Unit
Capacitance Unit
Signal Frequency Unit
Any consistent measure works, peak or RMS; the output comes back in the same one.
Widget