Spring Constant Calculator

This page works out a spring rate three ways. Measure a spring by hanging a known force on it and reading the deflection, and it returns k in N/m, N/mm, lbf/in and kgf/mm along with the energy stored; give it the wire diameter, mean coil diameter, active coil count and wire material instead, and it uses k = G d^4 / (8 D^3 n) with the standard shear modulus for that material, reporting the spring index and the Wahl stress factor as well. The third action combines two or three springs in series or in parallel. It is a rate calculation only, so solid height, free length, buckling and fatigue life are not covered.

Calculator Type
Force Unit
Deflection Unit
The load that produced the deflection below.
How far the spring compressed or stretched.
Widget
Dimensions Are In
Centre of wire to centre of wire, which is the outside diameter minus one wire diameter.
Total coils less the dead ends: subtract 2 for squared or squared-and-ground ends, 1 for plain-ground ends.
Widget
Rates Are In
Widget