Timecode Calculator

This tool does timecode arithmetic on the frame count rather than on the four printed fields, which is what makes drop-frame come out right. Enter two timecodes to add or subtract them, an in point and an out point to get a clip duration, or convert either way between a timecode and a frame number. Ten frame rates are covered, including 29.97 and 59.94 in both drop-frame and non-drop form, and an impossible drop-frame label is rejected rather than quietly accepted. Every result also carries the real wall-clock length, which is not the same as the timecode at any rate that is not a whole number of frames per second.

Calculator Type

Both values are read at the same frame rate, added on the frame count, and written back out.

Four fields: hours:minutes:seconds:frames.
A duration is written the same way, so 45 seconds and 20 frames is 00:00:45:20.
Drop-frame only exists at 29.97 and 59.94. Everything else counts straight through.
Widget

How long a clip is, from its first frame to where it ends.

The first frame of the clip.
The frame the clip runs to.
Drop-frame only exists at 29.97 and 59.94. Everything else counts straight through.
Widget

The frame count a timecode stands for, and how long that is on a clock.

Four fields: hours:minutes:seconds:frames.
Drop-frame only exists at 29.97 and 59.94. Everything else counts straight through.
Widget

The timecode a frame count lands on.

Counted from frame 0 at 00:00:00:00.
Drop-frame only exists at 29.97 and 59.94. Everything else counts straight through.
Widget