Hammock Hang Calculator

This works out where the straps go when you hang a gathered-end hammock between two trees. Enter the gap between the anchors, the hammock length, the hang angle and the sit height you want, and it returns the strap height on each tree, the suspension length per side, the sag and the tension in each line. A second mode runs it backwards and gives the anchor spacing that suits a strap height you can actually reach. The loaded hammock is modelled as two straight runs of fabric meeting at the low point, so strap stretch, tree lean and sloping ground are not in it.

Calculator Type
Units
The pair you pick here reads every box below, in the order it names them: the tree spacing and the hammock in feet or metres, the heights in inches or centimetres, the load in pounds or kilograms.

Enter the gap between the trees, the hammock length and the hang angle you want. It returns how high up each tree the strap goes, how much suspension you need on each side, and what the anchors are being pulled with.

The fabric length the maker quotes, gathered end to gathered end.
30 degrees is the usual recommendation.
You plus quilts, gear and anything hung off the ridgeline.
Widget
Units
The pair you pick here reads every box below, in the order it names them: the hammock in feet or metres, the heights in inches or centimetres, the load in pounds or kilograms.

Work the other way round: you know how high you can reach or how high the strap has to go, and you want the tree spacing that gives the hang angle you want.

Widget