Gambrel Roof Calculator

A gambrel is the barn roof shape, a steep lower slope from the eave up to a break and then a shallow upper slope to the ridge. Give it the span, the two pitches and how far in the break sits, and it returns the height at the break and at the ridge, each rafter with and without its sloped tail, both roof angles, the cut angles at the break and the ridge, and the roof area if you add a building length. A second tab lays the roof out the traditional way on a semicircle split into four equal arcs, which fixes the slopes at 67.5 and 22.5 degrees from the span alone and makes all four rafters the same length, and a third tab works the pitches back out of a roof you have measured. All of it is geometry, so nothing here says what size or grade of lumber will carry the load.

Calculator Type
Measurements In
Spans, runs, heights and the building length are read in feet or in metres, and the eave overhang in inches or in millimetres. Every length that comes back follows the same choice.
Pitches Given As
A rise in 12 is a ratio and is the same number in any unit system, but a roof outside North America is normally specified as an angle or as a percentage. Both pitch boxes below are read in whichever you pick here.

The usual way a gambrel is specified: a span, a steep lower pitch, a shallow upper pitch, and the point where the two meet.

Measured outside face to outside face of the walls.
The steep slope from the eave up to the break. Gambrels run steep here, commonly 18 in 12 to 30 in 12, which is 56 to 68 degrees.
The shallow slope from the break up to the ridge. It has to be shallower than the lower pitch or it is not a gambrel.
Measured horizontally from the outside of the wall, so it must be less than half the span.
In inches, measured horizontally. Leave it blank for a 12 in eave, or enter 0 for a roof cut off flush at the wall.
In feet, along the ridge. Leave it blank to skip the roof area.
Widget
Measurements In
Spans, runs, heights and the building length are read in feet or in metres, and the eave overhang in inches or in millimetres. Every length that comes back follows the same choice.

The layout barn framers lay out with a string: the eave, both breaks and the ridge sit on a semicircle the width of the building, split into four equal arcs. The span decides everything else.

Measured outside face to outside face of the walls.
In inches, measured horizontally. Leave it blank for a 12 in eave, or enter 0 for a roof cut off flush at the wall.
In feet, along the ridge. Leave it blank to skip the roof area.
Widget
Measurements In
Spans, runs, heights and the building length are read in feet or in metres, and the eave overhang in inches or in millimetres. Every length that comes back follows the same choice.

You have a barn in front of you and a tape. Measure the span, how far the break sits in from the wall, and the two heights, and this gives back the pitches and the rafter lengths.

Measured outside face to outside face of the walls.
Measured horizontally from the outside of the wall, so it must be less than half the span.
Widget