Bias Tape Calculator

Bias strips joined end to end use the whole area of the cloth, so a length of tape and a square of fabric are the same number seen two ways. Give the tape length and the finished width and this returns the square to cut, the cut strip width for single fold, double fold or a flat strip, and the yardage off the bolt. A second action turns it round for a piece you already own, and a third measures the edge you are binding so you know what length to ask for. A waste allowance covers the end triangles and the joins, and the two directions stay exact inverses at any setting. Quilt binding is a different calculation and has its own tool.

Calculator Type
Measured In
This sets the unit of the two strip widths below and of the answers as well. Centimetres or metres make the whole form metric; inches, feet or yards leave it in inches.
The width of the tape when it is folded and pressed, which is the size a bias tape maker is named for. A 1/2 in maker and a 12 mm maker are the same tool: enter 0.5 in inches or 1.2 in centimetres. Leave it blank for that usual size.
Leave it blank unless the kind of tape above is the custom one. The usual strip is 2 in, or 2.4 cm in centimetres.
Covers the two end triangles trimmed off the run, the cloth the joins swallow and a margin for error.
Pick the bolt in front of you. The inch widths are the quilting and dressmaking bolts sold in the United States; 110, 140 and 150 cm are the European ones. The list reads in whichever unit the length above is measured in.
Widget
Measured In
Applies to every measurement on this form, and to the answers. The arithmetic is a ratio of lengths, so the unit cancels out.
In inches. A 1/2 in maker and a 12 mm maker are the same tool, so leave it at 0.5 in for the usual size.
Only used for the custom kind of tape. In inches, where the usual strip is 2 in.
Widget
Measured In
Applies to both sides, to the allowance below and to the answers.
Widget