Spoke Length Calculator

This tool works out how long the spokes need to be for a bicycle wheel build. Enter the rim's effective rim diameter, the flange diameter and centre-to-flange distance for each side of the hub, the spoke count and the crossing pattern, and it returns a length for the left and right sides along with the whole-millimetre size to order. The two sides usually differ, because the flanges rarely sit the same distance from the middle of the hub. Every answer is only as good as the ERD behind it, and a figure copied from a rim chart rather than measured is the usual reason a build ends up a couple of millimetres out.

Measure the hub and look up the rim ERD, then this gives the length for each side.

Measured to where the nipple seats, so it already allows for the nipple. Not the bead seat diameter.
The circle the spoke holes sit on, not the outside edge of the flange.
From the middle of the hub, halfway along the locknuts, out to the left flange.
On a rear wheel this is the drive side, and it is the smaller of the two.
3 is the usual build. 0 means radial, straight out from the hub.
Leave at 2.6 unless you know otherwise. Half of it is taken off the length.
Widget