Rip Rap Calculator

Rip rap goes on a slope, and a slope is longer than the ground it covers, so ordering off the plan area comes up short. Give this the length of bank, the height of the face and the side slope and it works out the face area, the layer thickness from the 1.5 x D50 minimum, the volume, the tonnage, the bedding layer, the geotextile and the truck loads. A second action does the same for a trapezoidal ditch from its bottom width, depth and side slopes, and a third turns a tonnage you already have into the run of bank it will armour. Weight comes from the rock type and the voids in the placed layer rather than a single density, because dumped and hand-placed stone are not the same. It does not choose the stone size: D50 is a design decision and belongs on the drawing, so put in the one you were given.

Calculator Type
Measurements In
Lengths and heights in feet, stone size and layer thickness in inches, weights in short tons of 2000 lb. Slope ratio, specific gravity, voids and the waste allowance are ratios and read the same either way.
Enter 2 for a 2H:1V bank, 3 for 3H:1V. Rip rap is rarely laid steeper than 1.5H:1V. A ratio, so it reads the same in either unit.
Leave at zero to use the 1.5 x D50 minimum.
Around 35% for dumped stone, nearer 25% for placed or hand-set work.
In inches; enter 0 for none. Blank takes a 4 in course.
In pounds per cubic foot. Blank takes 105 lb per cu ft.
Per short ton of 2000 lb.
Short tons, or metric tonnes in metric. Blank takes 20 either way.
Widget
Measurements In
Lengths and heights in feet, stone size and layer thickness in inches, weights in short tons of 2000 lb. Slope ratio, specific gravity, voids and the waste allowance are ratios and read the same either way.
Enter zero for a V ditch with no flat bottom.
Leave at zero to use the 1.5 x D50 minimum.
Per short ton of 2000 lb.
Short tons, or metric tonnes in metric. Blank takes 20 either way.
Widget
Measurements In
Lengths and heights in feet, stone size and layer thickness in inches, weights in short tons of 2000 lb. Slope ratio, specific gravity, voids and the waste allowance are ratios and read the same either way.
Short tons of 2000 lb, or metric tonnes in metric.
Leave at zero to use the 1.5 x D50 minimum.
Widget